controlling a Lego light kit with a Raspberry Pi Pico W via an API call to the Pico
This project was started with a desire to turn a Briksmax light kit for the Lego kit "Death Star Trench Run" (kit #75329) controlled by a Raspberry Pi to attach to a Twitch chatbot command called !pewpew.
Here it is in action:
Successful stream tonight, albeit with some pretty newb soldering skills, but our !pewpew chat command works great!
— w. ian douglas 🇨🇦🇺🇸🥑🎙️ (@iandouglas736) January 6, 2023
Now to get the RPi Pico to run the code without needing to be plugged into the PC... pic.twitter.com/tBpbERUAuz
- Raspberry Pi Pico W with header pins soldered on (at a minimum you only need to solder the pins you'll actually use)
- for me that was:
- pin 9, 10, 11, 12, 14, 15 for the 6 LEDs I want to blink
- pin 13 for the ground that all LEDs will share
- pine 38 and 40 to power the trench run lights that will always stay on (5 of them)
- soldering the tiny Bricksmax wires to larger female socket ends to connect to the Pico's pins was the hardest part of the project
- if I had to do this over again, I might strip more of the wires, wrap the wire all around the Pico's connector and solder it directly onto the Pico connector pad instead of dealing with pins and sockets
- for me that was:
- Micropython installed
put your wifi credentials in config.py
there are a few helper methods defined in main.py to reset LEDs, make two of them blink in an alternating pattern, and more